|
The
P0610 Dual DC Motor Controller module also includes 4 opto-isolated
digital inputs, 6 non-isolated digital I/O and 2 analog inputs.
Therefore they can be used
with a wide range of sensors, which enables a large selection of applications
to be implemented directly and easily.
The
module is supplied pre-programmed with a basic 2 channel motor
controller. This allows the speed and direction to be controlled. The 4 opto-isolated
inputs are used as limit inputs, 2 per motor channel. Take a look at our
downloads page for examples of
firmware
and applications to use with our products. All downloads are free of
charge.
The module has been designed to ease the task of wiring. All motor drive
signals can be connected directly from the backplane to the motor in
screened cable. There is no need for splicing and the same also applies for
many sensor configurations. This reduces the cost and complexity of
wiring looms and increases reliability.
Compact
Control Design Limited
provide full programming support for the
P0610 Dual DC Motor Controller module,
as with all our other
MonCon boards. We provide
linker scripts, header and include files and programming examples that
enable you to write your own custom applications in assembler and C.
We also provide a development service providing application firmware to
your specification.
Download
the datasheet for the
P0610 Dual DC Motor Controller module
| Purchase 1-9 modules |
£67.00 each |
| Purchase pack of 10 modules |
£650.00 per pack |
For
enquiries and to purchase the P0610 Dual DC Motor Controller
Module contact Compact Control Design at sales@compactcontrol.co.uk.
Site
Map
|
