P0613 DC Motor Driver Module

[ Up ] [ P0612 Stepper Driver Module ] [ P0613 DC Motor Driver Module ] [ P0614 Driver Evaluation Board ] [ P0615 Mini Regulator Module ] [ P0701 USB PIC Microcontroller Module ] [ P0704 PIC Development Board ]

 

Features for the P0613 DC Motor Driver Module

The P0613 DC Motor Driver module provides a high specification DC motor driver in a small, compact package. The control interface of the module can be connected directly to a microcontroller or an I/O board on a PC. Therefore this enables motors, valves etc to be controlled easily and at a low cost.

 

The P0613 DC Motor Driver Module features are:

P0613 DC Motor Driver Module

  • Ideal for dc motors and electromagnets

  • Motor supply voltage 8 to 36 V

  • Maximum drive current 2.5 Amp

  • Pulse and Direction inputs

  • Pulse Width Modulation control up to 100KHz

  • Mode input for controlling motor braking

  • Sleep input for power saving

  • Short circuit and over temperature protection

  • Fault output pin activates if short circuit or over temperature detected

  • 66 x 30 mm board size, 12mm high, therefore small sized and compact

  • Adapter available providing easy to use screw terminals for all connections

  • All control inputs are opto-isolated

  • No heat sink required
The P0613 DC Motor Driver Module can easily be controlled by the P0701 USB PIC Microcontroller Module from Compact Control Design Limited. Take a look at our downloads page for examples of firmware and applications to use.

Download the datasheet (PDF format)

Purchase 1 to 9 modules £17.00 each
Purchase packs of 10 modules £150.00 per pack

Purchase the P0613 DC Motor Driver Module from the Compact Control Design web shop through this link.

A PIC Development Board is available allowing quick and easy prototyping and development of motion control projects.

An Evaluation Board is available allowing quick and easy evaluation of the P0613 DC Motor Driver module.

Site Map